When sewing swimsuit fabric on a standard sewing machine we are told to use a stretch needle. When it comes time to serge the same material we a left with standard serger needles, which are not stretch needles. Ballpoint serger needles can be hard to come by too. I find most don’t even know they exsists for their serger. In the video below I show you how to test if your serger or coverstitch machine can use standard stretch sewing machine needles.
Note! This technique should work on almost all domestic coverstitch machines – this includes the feature offered on all of the 5 thread sergers. The exception is the Babylock version and of course industrial coverstitch machines. You can simply chain off the end on of the stitch on these machines.
I discovered a way to use a part of the Hem Guide as a guide on my Janome CoverPro 1000CPX machine to hem thicker fabrics that will NOT fit in the attachment.
Here are the details:
Here is the hem guide.
Remove the 2 white screws as shown.
Remove the bracket.
Place it in on your machine and align it with the holes. The hole on the left is the only one we’ll be using.
Put the foot in the down position and align the needles.
Tighten the screw. You’ll have to push down on it to get it to catch before you start screwing it into the hole.
Be sure and flatten your seam to verify the alignment. In other words hold it exactly they way you’ll sew it.
Helpful hint…. I baste my side seams to keep them perfectly aligned.
Turn your fabric over and put the foot down. Turn the needles to the down position by hand.
One other thing. I found that moving the needles a bit more to the right (inside the seam) compared to my image shown here helps prevent some stitches from barely catching the seam.
People may ask why go through that trouble when you already have an attachment that does hems:
I sew manly clothing for myself. This means thicker fabrics. When you look at the design of the hem guild it is obvious they didn’t design it for mens clothing. Thin silks and knits that ladies wear go through with no problem. However, put some thicker fabrics through it and get ready for disaster. Below is an image showing my attempt to get a medium weight fleece fabric through the hem guide:
As you can see the white guild that slips over the folded seam can’t fit over the fabric. And don’t even try to sew because it will simply not slide under it – resulting in a mess.
Using a seam guide from a standard sewing machine
I also tried the seam guide from my straight stitch machine. It worked great as well. In the images below I show the guide installed on the machine and the stitching results:
Lining up for a 1/2 inch seam
The backside seam results
The front side seam results
I hope this post was helpful. I know it has made my hemming thicker fabric much more accurate for myself.